Adjusting The Heater; Switching On The Aquarium; Enhancing The Process Of Filtration (Mir 60) - Rewa Mirabello MIR 30 LED Instrucciones Y Garantía

so, follow these simple steps:
• Open the bag contacting the ventilation system, assemble all the component parts of the pressure-regulating filter and connect
it to the elastic tube (Fig. 15).
• Open the AIR cap located under the pump and insert the elastic tube into the hole (Fig. 16).
• Set the desired air pressure, lock the mechanism and the connection tube to the special clamps located under the internal unit
cap (Fig. 17).
V.h ADJUSTING THE HEATER
Most ornamental fish require water heated to a temperature that ranges from 24°C to 28°C, depending on the species. It is very
important to keep the water temperature constant, therefore NEWA Mirabello aquarium are fitted with an accurate and reliable
NEWA Therm Eco automatic submersible heater, with a thermostat that can be adjusted from a minimum of 18°C to a maximum
EN
of 32°C. The heater can be adjusted at any time: when in operation, the incorporated light bulb will be switched on. To adjust
the heater, proceed as follows:
1. Remove the lid of the filtering area or the heater lid.
2. Adjust the desired temperature without removing the aquarium heater by using a special handle located under the NEWA
Therm eco heater (Fig. 18). It is necessary to periodically monitor the temperature with a special immersion thermometer to
ensure safety. WARNING: If you need to remove the heater from the filter, make sure that the heater cord is unplugged.
V.i SWITCHING ON THE AQUARIUM
WARNING: connect the electrical appliances to the power supply only after setting up the aquarium as required and filling it
with water.
Fill the aquarium tank with water to a predefined level, given that the minimum distance between the water surface and the
lamp should be 15 mm when the cover is closed (Fig. 19).
2. Insert the filter cartridge/s into the filtering compartment supplied.
3. Connect the LED power supply unit with its own power supply via the connector.
4. Insert the plugs into the power sockets, carefully following the safety instructions given in Chapter I. From this point onwards,
the power supply cables should not be disconnected unless regular cleaning or maintenance operations are to be carried out.
5. Check that the various appliances are operating (in the event of a fault, see Chapter VIII):
• Water should come out of the pump outlet;
• The heater indicator light should switch on when the water temperature is lower than the set temperature;
• When the lights buttons are pressed, they should switch on.
6. Wait for the water temperature to reach the value set in the heater.
7. Proceed with adding any fish according to your own experience and complying with the "good practice" regulations for
aquariums.
V.l ENHANCING THE PROCESS OF FILTRATION (AQUARIUM MIR 60/70)
SUPPLEMENTED BY A SECOND MIRA FILTER
SIn case it is necessary to strengthen the system of filtering, please do the following:
1) Buy a NEWA Mirafilter MF100 in stores specializing in the sale of aquariums.
2) Attach only 2 suckers to the back of the filter and determine the location of the filter in the aquarium.
3) Mount the optional filter on specific support hooks and press down the lower part to fix 2 suckers.
4) Use a crosshead screwdriver to remove the screw and open the small upper window located in the left part under the
aquarium cover.
5) Remove the window by pressing the rear block (Fig. 21).
6) Pull the power cord out of another filter making S around special rod. This will prevent from the wrong control that may detach
the filter inside (Fig. 22).
7) Close the window and fix it with a special screw.
8) The excess of the cord inside the aquarium can be fixed with special locking mechanisms.
22