Battery Pack - Metabo MBS 18 LTX 2.5 Manual Original

en ENGLISH
cause a rebound. There is a risk of injury in this
case.
4.1 Special safety instructions for cordless
tools:
Remove the battery pack from the tool...
- ...before making any adjustments, changing tools,
maintaining or cleaning.
- ...if the operator moves away from the tool.
- ...prior to the removal of blockages.
- ...after touching a foreign body in order to check
the tool for damage.
- ...for immediate checking when the tool starts to
vibrate excessively.
Avoid unintentional starting: Make sure that the tool
is switched off before fitting the battery pack.
Protect battery packs from water and
moisture!
Do not expose battery packs to fire!
Do not use faulty or deformed battery packs!
Do not open battery packs!
Do not touch or short circuit battery pack contacts!
A slightly acidic, flammable fluid may leak
from defective Li-ion battery packs!
If battery fluid leaks out and comes into
contact with your skin, rinse immediately
with plenty of water. If battery fluid leaks out
and comes into contact with your eyes, wash them
with clean water and seek medical attention
immediately!
Reducing dust exposure:
Some of the dust created using this power tool
may contain chemicals known to cause
cancer, allergic reaction, respiratory disease, birth
defects or other reproductive harm. Some of these
substances include: Lead (in paint containing lead),
mineral dust (from bricks, concrete etc.), additives
used for wood treatment (chromate, wood
preservatives), some wood types (such as oak or
beech dust), metals, asbestos.
The risk from exposure to such substances will
depend on how long you or people nearby are
exposed to them.
Do not let particles enter the body.
Do the following to reduce exposure to these
substances: Ensure good ventilation of the
workplace and wear appropriate protective
equipment, such as respirators able to filter
microscopically small particles.
Observe the relevant guidelines for your material,
staff, application and place of application (e.g.
occupational health and safety regulations,
disposal).
Collect the particles generated at the source, avoid
deposits in the surrounding area.
Use only suitable accessories. In this way, fewer
particles enter the environment in an uncontrolled
manner.
Use a suitable extraction unit.
12
Reduce dust exposure with the following measures:
- Do not direct the escaping particles and the
exhaust air stream at yourself or nearby persons
or on dust deposits.
- Use an extraction unit and/or air purifiers.
- Ensure good ventilation of the workplace and
keep clean using a vacuum cleaner. Sweeping or
blowing stirs up dust.
- Vacuum or wash the protective clothing. Do not
blow, beat or brush.
5. Overview
See pages 2 and 3.
1 Clamping lever for tensioning the saw blade
2 Battery pack release button

3 Battery pack *

4 Capacity and signal indicator *
5 Capacity indicator button *
6 Allen key
7 Front handle
8 Locking button
9 Trigger
10 Rear handle
11 LED light
12 Guide rollers
13 Parallel guide
14 Saw blade *
15 Nut (2x)
16 Adjusting screw (2x)
17 Saw blade protection plate
18 Hanging hook
19 Pulleys
20 Rubber tyres
* depending on equipment / not included in the
delivery
6. Assembly,
Initial Operation and Setting
Remove the battery pack from the tool before
any adjustments, conversions, servicing or
cleaning are performed. Make sure that the tool is
switched off before fitting the battery pack.
6.1 Battery pack
Charge the battery pack (3) before use.
Recharge the battery pack if performance
diminishes.
The ideal storage temperature is between 10°C and
30°C.
"Li-Power" Li-ion battery packs have a capacity and
signal indicator (4):
- Press the button (5); the LEDs indicate the charge
level.
- The battery pack is almost flat and must be
recharged if one LED is flashing.