Membrane Replacement
• Close Feed Water Valve
• Open Faucet and drain any remaining water from system
• Open membrane housing and remove used membrane
• Follow the same procedure as RO membrane installation to replace RO membrane.
Troubleshooting
PROBLEM
No product water
Not enough product water
Pump not running
Pump is running but system is not
producing water
System does not shut off
Abnormal pump noise
No drain water
Tubing leaks
10
+1-503-GENPAR-6 - www.mygenpar.com
CAUSE
Water supply if off
Water supply is blocked
Feed water valve is plugged
No drain flow
Low feed water pressure
No power supply or loose connection
Transformer burnt out
Pre-filters plugged
Inlet solenoid valve not working
Auto shut off switch is not working
Pre-filters plugged
Plugged drain flow restrictor
Tubing connection incorrect.
Defective or damaged tubing
Genpar Industries LLC USA
SOLUTION
Turn on feed water
Clear restriction
Open valve or unplug
Clear or replace check valve
Check source water supply
Turn on power supply
Replace transformer
Replace filters cartridges
Repair o replace valve
Repair or replace switch
Replace filter cartridges
Replace
Check / reinstall tubing
Replace section of tubing