Before Your Start; System Components - Genpar NURFILTER Blue Tide Manual De Instalación Y Mantenimiento

Before you Start
• Read through all instructions before beginning installation and using this system. Follow all steps exactly or risk
damaging system /incorrect operation.
• This system contains filters that need to be replaced at certain intervals. Replacement intervals will vary according to
use, please contact your local dealer for details.
• Please install system on potable water only. On non-potable water sources, system will not function properly and
additional pre-treatment may be needed.
• Ensure source water pressure is between 14.5 – 43.5 psi. If source water pressure exceeds maximum pressure a pres-
sure reduction valve may be needed, consult your local dealer
• Ensure source water temperature is between 5ºC – 45ºC. System will not function properly if these temperatures are
exceeded. DO NOT INSTALL ON HOT WATER SOURCE.
• Do not use system on noticeably contaminated water such raw sewage or well water.
• This unit operates on 110V-240V power. Please ensure you are using the correct power source.
Caution
• Do not disassemble, open or modify this unit. Tampering with the unit may cause failure or damage and will void
warranty.
• Do not cover the unit, as this will prevent proper heat dissipation and can cause damage or fire.
• Do not place objects on top of the unit as this may cause damage to the unit and may cause leaking.
• Follow all recommended operating pressures and temperature, failure to do so will cause damage to the unit and void
warranty.

System Components.

1.
Feed Water Valve
2.
Tee Fitting
3.
Low Pressure Switch
4.
PP Spun Fiber
5.
Granular Carbon Filter
6.
Block Carbon Filter
7.
Inlet Solenoid Valve
8.
Booster Pump
4
+1-503-GENPAR-6 - www.mygenpar.com
Genpar Industries LLC USA
9.
Membrane Housing.
10. RO Membrane
11. Check Valve
12. Drain Restrictor
13. By-pass flush valve
14. High Pressure Switch
15. Inline Carbon Filter
16. Faucet