Reverse Caution Mode; Driving On Slopes - Cub Cadet CC 30 Manual Del Operador

Reverse Caution Mode

The REVERSE CAUTION MODE position of the key switch module
allows the tractor to maneuver in reverse with the blade (PTO)
engaged.
NOTE: Mowing in reverse is not recommended.
WARNING!
the tractor in the REVERSE CAUTION MODE. Always
look down and behind before and while backing. Do
not operate the tractor when children or others are
around. Stop the tractor immediately if someone
enters the area.
To use the REVERSE CAUTION MODE:
NOTE: The operator MUST be seated in the tractor seat.
1. Start the engine as previously instructed on the previous
page.
2. Turn the key from the NORMAL MOWING (Green) position
to the REVERSE CAUTION MODE (Yellow) position of the
key switch module. See Figure 5-2.
Indicator
Light
Reverse
Caution
Mode
Position
Stop
position
3. Press the REVERSE PUSH BUTTON (Orange, Triangular
Button) at the top, right corner of the key switch module.
The red indicator light at the top, left corner of the key
switch module will be ON while activated. See Figure 5-2.
4. Once activated (indicator light ON), the tractor can be
driven in reverse with the cutting blade (PTO) engaged.
5. Always look down and behind before and while backing to
make sure no children are around. After resuming forward
motion, return the key to the NORMAL MOWING position.
The REVERSE CAUTION MODE will remain activated until:
a. the key is placed in either the NORMAL MOWING
position or STOP position or,
b. the operator leaves the seat.
20 S 5— o
ection peration
Use extreme caution while operating
Reverse
Push
Button
Normal
Driving
Mode
Start
position
Figure 5-2

Driving on Slopes

Refer to the SLOPE GAUGE in the Important Safe Operation
Practices section to help determine slopes where you may
operate the tractor safely.
WARNING!
Do not mow on inclines with a slope in
excess of 12 degrees (a rise of approximately 2 feet for
every 10 feet). The tractor could overturn and cause
serious injury.
• Mow up and down slopes, NEVER across.
• Exercise extreme caution when changing direction on
slopes.
• Watch for holes, ruts, bumps, rocks, or other hidden
objects. Uneven terrain could overturn the machine. Tall
grass can hide obstacles.
• Avoid turns when driving on a slope. If a turn must be
made, turn down the slope. Turning up a slope greatly
increases the chance of a roll over.
• Avoid stopping when driving up a slope. If it is necessary
to stop while driving up a slope, start up smoothly and
carefully to reduce the possibility of flipping the tractor
over backward.
Engaging the PTO (Cutting Blade)
Engaging the PTO (Blade Engage) transfers power to the cutting
deck. To engage the blade, proceed as follows:
1. Move the throttle control lever to the FAST (rabbit) position.
2. Grasp the PTO (Blade Engage) lever and pivot it all the way
forward into the engaged (ON) position.
NOTE: Keep the throttle lever in the FAST (rabbit) position
for the most efficient use of the cutting deck.
IMPORTANT: The PTO (Blade Engage) lever must be in the
disengaged (OFF) position when starting the engine, when
traveling in reverse, and if the operator leaves the seat. Refer to
Safety Interlock Switches in the Operation section of this manual.
Mulching
A mulch kit has been supplied with your unit. Mulching is a
process of recirculating grass clippings repeatedly beneath
the cutting deck. The ultra-fine clippings are then forced back
into the lawn where they act as a natural fertilizer. Refer to the
Assembly & Set-up section of this manual for instructions on how
to install the mulch kit.