Rear-Facing Installation With Latch - Graco ComfortSport Manual De Instrucciones

REAR-FACING
1
LATCH belt must be routed through
opening in car seat for
(see page 23, fig. j).
Belt must lay flat and not be twisted.
2
Adjust car seat to recline position
(see pages 18 and 19, fig. b) and place
rear-facing on vehicle seat equipped with
LATCH anchors.
3
For ease of installation, extend
to its maximum length.
4
Hook connectors to vehicle lower anchors
(fig. a). Pull connectors to be sure they are
securely attached to the anchor points. (fig. b).
5 Press down firmly in center of car seat while
pulling LATCH adjustment belt. (fig. c).
8
INSTALLATION WITH
rear-facing mode.
LATCH belt
LATCH
6
Pull front to back and left to right to check for
secure installation (fig. d).
Check that the lower anchorage belt stays
tight and does not slip from the tightened
position. If it does not stay tight, try another
seating position or contact Customer Service
(see back cover).
7 Check level indicator on car seat.
Vehicle must be on level ground
and child in car seat when checking level
indicator.
Ball MUST be entirely in green zone (fig. e). If
necessary, place rolled towels under car seat, at
vehicle seat crease, until entire ball is in green
zone. Then re-check level indicator.
DO NOT use tether rear-facing. Tether must
be stored (see "Tether Storage" page 32).
Periodically check that car seat is securely
installed and properly leveled; adjust if
necessary.