Rear-Facing Installation With; Vehicle Seat Belts - Graco ComfortSport Manual De Instrucciones

REAR-FACING
WARNING
LATCH belt MUST be stored when
using vehicle seat belt to install car seat.
1
Store LATCH belt by attaching to connectors
through forward-facing openings
(see page 23, fig. k).
• Attach connectors to storage bar on each
side (fig. a).
• Adjust LATCH
slack by pulling adjustment belt.
2
Adjust car seat to recline position (see page 18
and 19, fig. b) and place
seat.
3
Thread vehicle seat belt through openings and
buckle belt.
4
Press down firmly in center of car seat to
compress vehicle seat cushion while tightening
vehicle seat belt (fig. b).
12
INSTALLATION WITH
belt to remove excess
rear-facing on vehicle

VEHICLE SEAT BELTS

Pull front to back and left to right to check for
5
secure installation (fig. c). Vehicle lap belt
MUST stay tight.
If not secure, see "Vehicle Seat Belts" page 26.
6
Check level indicator on car seat.
Vehicle must be on level ground and
child in car seat when checking level indicator.
Ball MUST be entirely in green zone (fig. d).
If necessary, place rolled towels under car seat,
at vehicle seat crease, until entire ball is in
green zone. Then re-check level indicator.
DO NOT use tether rear-facing. Tether must
be stored (see "Tether Storage" page 32).
Periodically check that car seat is securely
installed and properly leveled; adjust if
necessary.