General Safety Notes - Elbro TL 500 Instrucciones De Empleo

General safety notes

Please observe the following five safety rules:
1 Disconnect.
2 Ensure that the instrument cannot be turned back on again.
3 Ensure isolation from the main supply voltage (check that there is no
4 Earth and short-circuit.
5 Cover neighbouring parts that are under live electrical load.
WARNING
Unauthorized changes or modifications of the instrument are forbid-
den – such changes put the approval (CE) and safety of the instru-
ment at risk. In order to operate the instrument safely, you must al-
ways observe the safety instructions, warnings and the information in
the "Proper and Intended Use" Chapter.
WARNING
Please observe the following information before using the instrument:
| Do not operate the instrument in the proximity of electrical weld-
ers, induction heaters and other electromagnetic fields.
| After an abrupt temperature fluctuation, the instrument should be
allowed to adjust to the new temperature for about 30 minutes be-
fore using it. This helps to stabilize the IR sensor.
|
Do not expose the instrument to high temperatures for a long pe-
riod of time.
|
Avoid dusty and humid surroundings.
|
Measurement instruments and their accessories are not toys.
Children should never be allowed access to them!
|
In industrial institutions, you must follow the accident prevention
regulations for electrical facilities and equipment, as established
by your employer's liability insurance organization.
voltage on both poles).
16