Forest-Master ULTIMATE Manual Del Usuario página 12

STEP 5:
Remove the downward
pressure so that the long end
moves downwards causing
the chain to lock in both chain
tubes. The log should be
approximately level. The angle
of the log can be adjusted
by re-applying downward
pressure on the log and
pulling or pushing on the ends
of the chain.
WARNING: If it is necessary to adjust the chain to change the angle
of the log, always hold the chain by the ends, never close to the chain
tubes.
IMPORTANT: The weight of the log is sufficient to securely locate it in
the v-blades, do not apply downward pressure to the long overhanging
end of the log as this may result in damage.
IMPORTANT: Check that the log is secure and the sawhorse stable
before beginning to cut.
12
STEP 6:
Always begin by cutting
the initial few logs from
the long overhanging end,
then cut successive logs in
a sequence that maintains
approximately 1/3 of the
remaining log length in the
direction of the chain and
2/3 in the direction of the
back legs.
Ultimate Sawhorse