Operation∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙ 8 - Royal Sovereign RBC-2100 Manual Del Propietário

oPeRAtIon
1. Plug in power cable and turn on.
2. Select counterfeit detection mode.
When the machine is turned on the display will show the IR, UV, and MG indicators on. This means that all three counterfeit detection
modes are on. In order to turn any of these modes off, press the CHK button once. The preset display window will flash –CH
meaning that the control panel buttons are switched to the second function. Press the button for ADD/IR, BAT/UV, or +1/MG this will
turn off that function and the indicator for that function. Press the CHK button again to return to normal operation.
When a counterfeit note is detected the machine will count it, beep and then stop running. The bill on the top of the stacker is
the counterfeit or suspicious bill. Remove the bill and press the RESET button to continue counting. Since the counterfeit bill was
counted, place the remaining bills into the hopper again to recount.
3. Select bill counting settings.
Common counting mode
The machine is preset to a common counting mode. It will automatically count all of the bills placed into the hopper. The total number
of bills will be displayed on the counting display. Remove the bills from the stacker when counting is completed. When another set of
bills is placed into the hopper, the display will go back to 0 and begin counting again.
Add Mode
This mode is used to get an accumulative total of the bills counted. To turn this mode on press the ADD/IR button and the display
will show the ADD indicator on. The counting display will continue to add the total of bills counted up to 999, and then will resume
counting from 0. To turn off the ADD mode and return to common counting, press the ADD/IR button and the ADD indicator will turn
off. To clear the amount on the counting display press the CNT/CE button.
Batch counting mode
The machine is preset to common counting mode. To use batch mode press the BAT/UV button. The preset display will show 100. In
order to change the batch amount press BAT/UV to show 100, 50, 20, 10, or 5. After reaching 5 the display will turn back to normal
counting mode, just press the BAT/UV button again to reach a specific batch amount. If you need to count a more specific batch
amount, press the +1/MG button. This will add 1 until you reach your desired amount. Begin batch counting by placing bills into the
hopper. The machine will stop once it reaches that amount. To count more batches of the same amount, just remove the batch from
the stacker and another batch will begin counting. To exit batch counting mode press the CNT/CE button.
8