Connect The Wiring - Broan DECORATIVE Serie Manual De Instrucciones

INSTALL THE HOUSING
(continued)
Existing Construction
4. Place housing in opening so that its bottom edge is flush
with finished ceiling. Nail to joist through keyhole on both
sides. To ensure a noise-free installation, drive another nail
through the top hole of each mounting bracket.
5. Additional mounting holes are provided for installations
where access from above is inconvenient or not possible.
Nail or screw housing directly to joists or framing.
INSTALL THE DUCTWORK
NOTE: The duct connector has
a counter-balanced damper flap.
The flap will be "open" approx.
1" when duct connector is at-
tached to housing. This design
permits insulation to be in direct
contact with fan/light housing
per UL (Underwriters Labora-
tories) standards. The slightest
backdraft, however, will close the
damper flap, preventing air from
entering unit or finished space.
1. Snap the damper/duct connector onto housing. Make sure
that tabs on the connector lock into slots in housing. Top of
damper/duct connector should be flush with top of housing.
NOTE: Make sure damper flap is in place inside of duct

connector. If it is not:
‚
to snap flap back into place.
ADDITIONAL
MOUNTING
FLUSH
Squeeze top and bottom of connector
2. Connect 4" round duct to damper/duct connector and
extend duct to outside through a roof or wall cap. Check
damper to make sure that it opens freely. Tape all duct
connections to make them secure and air tight.

CONNECT THE WIRING

DUAL CONTROL
(purchase separately)
LIGHT
FAN
1. Wire unit following diagram above. Run electrical cable as
direct as possible to unit. Do not allow cable to touch sides
or top of unit after installation is complete.
HOLES
ATTACH THE GRILLE PAN
AND GLASS SHADE
1. Locate the grille pan over
the fan housing and con-
nect the wiring harness
plug into white recep-
tacle in the fan housing.
2. Insert rod through center
hole of grille pan. Use
washer between collar
on rod and pan.
3. Thread rod onto grille
screw in housing, until
pan is tight against ceil-
ing.
4. Install bulbs. Use 60 Watt
(maximum), candelabra
base bulbs.
5. Place glass shade over
mounting rod and align
shade onto grille pan.
Secure glass shade to
grille pan with finial cap
and finial nut as shown.
6. Restore electrical power
and check operation of
the unit.
MODEL 754RB
BLACK RED
WHITE GROUND
(bare)
BLUE
SWITCH BOX
WIRING
PLATE
120 VAC
LINE IN
Page 3
WHITE
RECEPTACLE
(LIGHT)
BLACK
RECEPTACLE
(FAN)