Components; Symbols; Operation; Capacity Indicator - Mafell A10 M Traducción Del Manual De Instrucciones Original

4

Components

(Fig. 1)
(1) Exchangeable chuck
(2) LED light
(3) Adjusting ring – torque preselection
(4) Gear change slide - first or second gear
(5) Capacity and signal display
(6) Belt clip, can be used on both sides
(7) Sense of rotation selector switch, double sided
(8) Switch trigger
(9) Unlocking mechanism rechargeable battery
(10) Rechargeable battery

(11) Bit adapter

4.1 Symbols

Movement direction
First gear
Second gear
Screwing
Drilling
Nm Torque
5

Operation

5.1 Capacity indicator

(Fig. 1)

Charge the rechargeable battery prior to use.

Recharge the rechargeable battery in case of
loss of power.

The optimum storage temperature is between
10 °C and 30 °C.
5.2 Removing and inserting the rechargeable
battery
(See Fig. 2)

5.3 Sense of rotation, transport lock

Setting the switch-on lock (Fig. 3)

5.4 Selecting the gear speed

(Fig. 1)
Actuate the switch slider (4) only
when the motor is standing still!

5.5 Adjusting the drilling settings

(Fig. 4)

Set the torque with torque control by turning the
adjusting ring (3). Intermediate positions are
possible.

= Setting the drilling level (max. torque,
without
To prevent a motor overload, do not block the
spindle.

5.6 Switching on/off, setting the speed

(Fig. 1)
Switching on: Press the switch trigger (8). The
speed at the switch trigger can be changed by the
depth to which it is depressed.
Switching off: Release the switch trigger (8).

5.7 Quick-release chuck

(Fig. 5)

Detaching: Pull the locking ring forward and
pull off the chuck to the front.

Attaching: Pull the locking ring forward and
push the chuck onto the drilling spindle up to the
limit stop. (If necessary, turn the chuck slightly
to and fro.)

5.8 Belt clip

(Fig. 6)
Attaching: Push the belt clip together so that you can
insert it in the opening on the motor casing. Push the
belt clip that far into the opening until it clearly
engages. Push the red slide bar in direction of the
motor casing end and around the belt clip radius (stiff)
so that it engages in the motor casing. With that the
belt clip is securely fastened.
Detaching: Proceed in the reverse order as
described above.
The belt clip can be attached on both sides.
5.9 Bit adapter
(Fig. 1)
-17-
torque control).