IKEA SPOLAD Instrucciones De Instalación página 4

9.
Remove the short screws
Remove 2 short screws
and replace with long
screws provided.
Remove the short screws (3rd from top) on either side of the
inner door panel. Use tape to mark a
hole depth of approximately 1
using the door liner hole as a guide into the panel. Install the
2 remaining long screws.
Voxtorp Kitchen Door Front Installation
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
1.
Stand dishwasher upright
Using 2 or more people, stand the dishwasher up.
NOTE: Do not install kick plate until instructed to do
so in the dishwasher Installation Instructions.
4
Align top
edges
Customer-
supplied panel
/ " drill bit to gauge the
3
32
/ " (38 mm). Drill 2 pilot holes
1
2
2.
Panel template
Wood Panel Template
Centerline
W10195005A
Using the template provided, attach it to the backside of the
Voxtorp kitchen door front. Make sure that the center of the
template is aligned with the center of the door front and top
of the template is aligned to the top face of the door front.
3.
Predrill custom panel holes
NOTE: Do not drill deeper than
through panel. Pilot hole depths given are for
thick panel.
Mark 4 pilot holes on the door front using the template provided.
Predrill 4 pilot holes using a
drill bit to gauge hole depth. Drill pilot holes approximately
/ " (16 mm) into the door front.
5
8
Top of panel
Pilot
holes
/ " (16 mm) to keep from drilling
5
8
3 / " (19 mm)
4
/ " drill bit. Use tape to mark the
3
32