Zyxel P-334WT Guia De Inicio Rapido página 17

Internet Access Setup Complete
If you have any Internet access problems, follow the
on-screen instructions.
Click Finish to complete the wizard setup.
4 Troubleshooting
Note: If your computer cannot automatically communicate with the device, then see the multimedia
tutorial on how to set up your computer to receive an IP address dynamically or give it a fixed
one in the range specified in section
PROBLEM
None of the LEDs turn on when
you connect the P-334WT's
power.
Cannot access the P-334WT
from my computer.
ENGLISH
.
4.1
CORRECTIVE ACTION
Make sure that you have the correct power adaptor connected to the P-334WT,
it is plugged into an appropriate power source.
Check all cable connections. If the LEDs still do not turn on, you may have a
hardware problem. In this case, you should contact your local vendor.
Check the cable connection from your computer to the P-334WT.
If the P-334WT's IP address has changed, then enter the new one as the
website address.
Make sure your computer's IP address is in the same subnet as the P-334WT's
IP address (see section 4.1).
Ping the P-334WT from a computer on the LAN. Make sure your computer's
Ethernet adapter is installed and functioning properly. In the computer, click
Start, (All) Programs, Accessories and then Command Prompt. In the
Command Prompt window, type "ping" followed by the P-334WT's LAN IP
address (192.168.1.1 is the default) and then press [ENTER]. The P-334WT
should reply; otherwise see section 4.1.
17