Lenco IPD-4600 Guia Del Usuario página 14

Wake-up Alarm
Note: Following control operations are implemented from the remote control.
Wake to Buzzer (Beep sound)
When the alarm time is reached, the alarm 1
and the buzzer alarm will sound for one minute.
It goes into auto-Snooze mode if no button has been pressed. The alarm 1
(alarm 2 ) indicator binks. The buzzer turns off for the snooze time (around 10
2
minutes) then comes on again.
You may activate the snooze function after the alarm sounds by pressing the
SNOOZE button. The buzzer stops for the snooze time (around 10 minutes) then
comes again.
The snooze operation (including auto-snooze and manual snooze) can be
repeated max. 5 times within 50 minutes from the set alarm time.
To cancel the snooze before it expires, press the alarm 1
button and the unit will stay at standby mode.
To stop the alarm immediately after the buzzer sounds, you can also press the
alarm 1 ( alarm 2
1
Wake to Radio, iPhone/iPod
When the alarm time is reached, the selected alarm source Radio or iPhone/
iPod will automatically turn on. It starts softly and gradually becomes louder.
The alarm 1
It plays for 60 minutes then shuts off and resets itself for the following day.
During the activation of the alarm source, you may press the SNOOZE button
to active the snooze function. The alarm stops for the snooze time (around 10
minutes) then turns on again.
The snooze operation can be repeated max. 5 times within 50 minutes from the
set alarm time.
To cancel the snooze before it expires, press the alarm 1
button and the unit will stay at standby mode.
To stop the alarm immediately after the alarm sounds, you can also press the
alarm 1 (alarm 2
1
or button. It resets itself for the following day.
)
2
(alarm 2 ) indicator blinks.
1 2
) or button. It resets itself for the following day.
2
( alarm 2
1
14
) indicator blinks
2
( alarm 2 ) or
1 2
(alarm 2 ) or
2
1
1