Installation - Lenco IPD-4600 Guia Del Usuario

Back-up battery :
In case of a power interruption or AC power failure, the unit incorporated a DC3V
CR2032 type Lithium battery(included) to backup the clock, preset radio stations data.
The backup battery compartment located at bottom of the main unit.
Open the battery compartment lid.
(1)
Remove the insulation tab attached in the battery compartment.
(2)
Close the battery compartment lid.
(3)
Remote Control
The remote control operates on one DC3V CR2025 type Lithium battery (included).
To activate the remote control, remove the insulation tab attached in the battery
compartment.
Caution:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Warnings:
- Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
- Be sure that the battery are installed correctly. Wrong polarity may damage the unit.
- If the unit is not to be used for an extended period of time, remove the battery.
- Do not dispose of batteries in fire, battery may explode or leak.
AC-DC Power Adaptor Connection
The unit is powered by an external AC-DC power adaptor, required the output DC15V
2400mA (included).
(1)
Connect the adaptor's DC output plug to the DC-in jack of the main unit.
(2)
Firmly and securely plug the adaptor's AC plug into AC main outlet.

Installation

5