Brushing Modes - Philips sonicare DiamondClean Manual De Usario

Place the toothbrush bristles against the teeth at a slight angle
degrees , pressing firmly to make the bristles reach the gumline or
slightly beneath the gumline Fig.
Note: Keep the center of the brush in contact with the teeth at all
times.
Press the power on/off and mode button to turn on your Philips
Sonicare Fig.
Gently keep the bristles placed on the teeth and in the gumline.
Brush your teeth with small back and forth motion so the bristles
reach between the teeth Fig.
Note: The bristles should slightly flare. Do not scrub.
To clean the inside surfaces of the front teeth, tilt the brush handle
semi-upright and make several vertical overlapping brushing
strokes on each tooth Fig.
Begin brushing in section
seconds seconds in Deep Clean mode before moving to
section inside top teeth . Continue brushing in section
bottom teeth and brush for
Clean mode before moving to section
.
Note: To make sure you brush evenly throughout the mouth,
divide your mouth into
see chapter Features .
Note: After you have completed the brushing cycle, you can spend
additional time brushing the chewing surfaces of your teeth and
areas where staining occurs. You can also brush your tongue, with
the toothbrush turned on or off, as you prefer Fig.
Your Philips Sonicare is safe to use on:
- Braces brush heads wear out sooner when used on braces .
- Dental restorations fillings, crowns, veneers .

Brushing modes

To toggle through modes press the on/off button twice in less
than seconds.
.
.
.
outside top teeth and brush for
seconds
sections using the Quadpacer feature
.
seconds in Deep
inside bottom teeth Fig.
11
English
outside
.