Publicidad
Idiomas disponibles
Idiomas disponibles
Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
PowerBOSS™
To apply detergent follow these steps:
1.
Review use of spray tips.
2.
Prepare detergent solution as required by
manufacturer.
3.
Place small filter end of detergent siphoning tube into
detergent container.
Keep the detergent siphoning tube from coming in
contact with the hot muffler.
• When inserting the filter into a detergent solution bottle,
route the tube so as to keep it from inadvertently contacting
the hot muffler.
4.
Make sure black spray tip is installed.
NOTE: Detergent cannot be applied with the high
pressure spray tips (White,Yellow, or Red).
5.
Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray
gun and pump and start engine.
6.
Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
7.
Allow detergent to soak in between 3–5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow detergent
to dry on (prevents streaking).
IMPORTANT: You must flush the injection system after
each use by placing the filter into a bucket of clean water,
then run the pressure washer in low pressure for
1-2 minutes.
Pressure Washer Rinsing
After you have applied detergent, scour the surface
and rinse it clean as follows:
1.
Engage trigger lock to spray gun.
2.
Remove black detergent spray tip from nozzle
extension.
3.
Select and install desired high pressure spray tip
following instructions "How to Use Spray Tips".
CAUTION
www.mymowerparts.com
2600 PSI Pressure Washer
4.
Keep spray gun a safe distance from area you plan to
spray.
High pressure spray could cause you to fall if
you are too close to the cleaning surface.
• Keep spray nozzle between 8 to 24 inches away from cleaning
surface.
• Operate this unit on a stable surface.
• Be extremely careful if you must use the pressure washer from
a ladder, scaffolding or any other relatively unstable location.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
5.
Apply a high pressure spray to a small area and then
check surface for damage. If no damage is found, you
can assume it is okay to continue rinsing.
6.
Start at top of area to be rinsed, working down with
same overlapping strokes as you used for cleaning.
Cleaning Detergent Siphoning Tube
If you used the detergent siphoning tube, you must flush it
with clean water before stopping the engine.
1.
Place chemical injection siphon/filter in a bucket full of
clean water.
2.
Engage trigger lock on spray gun.
3.
Attach black cleaning detergent nozzle.
4.
Flush for 1-2 minutes.
5.
Shut off engine.
6.
ALWAYS point gun in a safe direction and squeeze
spray gun trigger to release retained high water
pressure.
IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures
above 125°F.The system engages to cool the pump by
discharging the warm water onto the ground.
12
OPERATION
WARNING
Publicidad
