T RO U B L E S H O OT I N G
BEFORE CALLING FOR SERVICE
Review the chart below first and you may not need call for service.
Problem
Compressor will not turn on.
During operation, the noise level
increases suddenly.
The of noise level changes.
During operation startup, operation
conversion, or operation stop, an
unusual sound is heard in the unit.
When the unit is used the first time,
there may be a slight odor.
Warm air is discharged.
The angle or operation of Louver is
abnormal.
There are liquid or white marks in the
bucket.
24
All manuals and user guides at all-guides.com
The follwing symptoms are normal
Possible Causes
• For 3 minutes immediately after the unit is turned off or Power Cord is plugged,
the unit will not operate to protect the compressor.
• If the relative humidity in the room goes below the level you have selected, the
Dehumidifier will turn itself off.
• When compressor starts to operate, (3 minutes after turning the switch ON, or in
Automatic Dehumidification Mode) the noise level increases.
• Depending on the angle of Louver, the noise level changes.
• Until coolant circulation becomes stable, the sound of coolant may be heard.
• As the temperature of the heat exchanger increases, odor may be temporarily
present.
• Since the air that was dehumidified by cooling gets warm by the condenser, the
airflow gets warm (There is no cooling function). This is normal.
• Press the AUTO Swing button again.
• This is the water generated in the factory test, or the trace of water evaporation.
This is normal.