Connect Vent; Level Dryer; Adjust Leveling Legs - Kenmore W10850308A Instrucciones De Instalación

CONNECT VENT

1.
Connect vent to exhaust outlet
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is clean.
Vent must fi t over dryer exhaust outlet and inside exhaust
hood. Check that vent is secured to exhaust hood with a
4" (102 mm) clamp.
2.
Move dryer to fi nal location
Move dryer to fi nal location. Avoid crushing or kinking vent.
20

LEVEL DRYER

1.
Level dryer
Check levelness of dryer from side to side. Repeat from
front to back.
NOTE: The dryer must be level for the moisture sensing
system to operate correctly.
Not Level
2.

Adjust leveling legs

If dryer is not level, prop up using a wood block. Use wrench
to adjust legs up or down, and check again for levelness.
LEVEL Not Level