Location Requirements - Kenmore W10850308A Instrucciones De Instalación

Tools needed for gas installations:
8" (203 mm) or 10"
(254 mm) pipe wrench
Pipe-joint compound
resistant to LP gas
Parts supplied (all models):
Leveling legs (4)
(Length and appearance of legs may vary according to model)
Parts package is located in dryer drum. Check that all parts
are included.
If using a power supply cord:
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
A UL listed 30-amp power supply cord, rated 120/240 volt
■
minimum. The cord should be type SRD or SRDT and be
at least 4 ft. (1.22 m) long. The wires that connect to
the dryer must end in ring terminals or spade terminals
with upturned ends.
A UL listed strain relief.
■
Parts needed: (Not supplied with dryer)
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements" before
purchasing parts.
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your dryer. For further information, call 1-844-553-6667 (U.S.) or
1-800-469-4663 (Canada).
Optional Equipment: (Not supplied with dryer)
Refer to your "Use and Care Guide" for information about
accessories available for your dryer.
8" (203 mm) or 10"
(254 mm) adjustable wrench
(for gas connections)
or

LOCATION REQUIREMENTS

You will need:
A location allowing for proper exhaust installation. See
■
"Venting Requirements."
A separate 15 or 20-amp circuit needed for gas dryers and
■
30-amp circuit needed for electric dryers.
If using power supply cord, a grounded electrical outlet located
■
within 2 ft. (610 mm) of either side of dryer. See "Electrical
Requirements."
Floor must support dryer weight of 200 lbs. (90.7 kg). Also
■
consider weight of companion appliance.
Level floor with maximum slope of 1" (25 mm) under entire
■
dryer. If slope is greater than 1" (25 mm), clothes may not
tumble properly and automatic sensor cycles may not operate
correctly.
For garage installation, place dryer at least 18" (460 mm)
■
above floor.
IMPORTANT: Do not operate, install, or store dryer where it will
be exposed to water, weather, or at temperatures below 45° F
(7° C). Lower temperatures may cause dryer not to shut off at
end of automatic sensor cycles, resulting in longer drying times.
NOTE: No other fuel-burning appliance can be installed in the
same closet as a dryer.
5