Safety and environment instructions
Do not use steam or steamed cleaning
•
materials for cleaning the refrigerator
and melting the ice inside. Steam may
contact the electrified areas and cause
short circuit or electric shock!
Do not wash the product by spraying or
•
pouring water on it! Danger of electric
shock!
In case of malfunction, do not use
•
the product, as it may cause electric
shock. Contact the authorised service
before doing anything.
Plug the product into an earthed
•
socket. Earthing must be done by a
qualified electrician.
If the product has LED type lighting,
•
contact the authorised service for
replacing or in case of any problem.
Do not touch frozen food with wet
•
hands! It may adhere to your hands!
Do not place liquids in bottles and cans
•
into the freezer compartment. They
may explode.
Place liquids in upright position after
•
tightly closing the lid.
Do not spray flammable substances
•
near the product, as it may burn or
explode.
Do not keep flammable materials and
•
products with flammable gas (sprays,
etc.) in the refrigerator.
Do not place containers holding liquids
•
on top of the product. Splashing water
on an electrified part may cause
electric shock and risk of fire.
Exposing the product to rain, snow,
•
sunlight and wind will cause electrical
danger. When relocating the product,
do not pull by holding the door handle.
The handle may come off.
Take care to avoid trapping any part
•
of your hands or body in any of the
moving parts inside the product.
Do not step or lean on the door,
•
drawers and similar parts of the
refrigerator. This will cause the product
to fall down and cause damage to the
parts.
Take care not to trap the power cable.
•
1.1.1 HC warning
If the product comprises a cooling system
using R600a gas, take care to avoid
damaging the cooling system and its pipe
while using and moving the product. This
gas is flammable. If the cooling system
is damaged, keep the product away from
sources of fire and ventilate the room
immediately.
C
The label on the inner left side
indicates the type of gas used in
the product.
1.1.2 For models with
water dispenser
Pressure for cold water inlet shall be
•
maximum 90 psi (6.2 bar). If your
water pressure exceeds 80 psi (5.5
bar), use a pressure limiting valve in
your mains system. If you do not know
how to check your water pressure, ask
for the help of a professional plumber.
If there is risk of water hammer effect
•
in your installation, always use a water
hammer prevention equipment in
your installation. Consult Professional
plumbers if you are not sure that there
is no water hammer effect in your
installation.
4 / 37 EN
Refrigerator / User Guide