Installation; Programming; Final Assembly - Metra 99-6536 Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION

It is highly advisable to read the following steps beforehand, to ensure a clear understanding of
what is to be expected. The following steps must be done in the order that they are numbered.
With the vehicle completely off:
1. Connect the 16-pin harness with stripped leads into port "B" in the touchscreen display.
2. Connect the 6536 harness to the wiring harnesses in the vehicle. These harnesses are the
ones removed in step 7 from dash disassembly. Then insert the 6536 harness into port "A"
in the touchscreen display. But do not install this harness until exactly before step 1 from the
Programming section. This is a timed process.
3. Connect the 4-pin harness with yellow RCA jacks into port "C" in the touchscreen display.
4. Connect the hazard harness into port "D" in the touchscreen display, and then to the wiring
harness in the vehicle.
5. Disregard port "E", it will not be used in this application.
6. Port "F" is an update port for future firmware upgrades.
7. Locate the factory antenna connector in the dash and complete all necessary connections to
the radio. Use the antenna adapter provided to adapt the factory antenna connector to the
aftermarket radio.
A
F
Note: DO NOT CONNECT!
B
C
D
E

PROGRAMMING

1. Refer to step 2 from the Installation section.
2. Press the push-to-start button to start the vehicle.
3. Program the kit:
a. Once the touchscreen display loads up, select the vehicle type.
b. Wait until the radio comes on, and the touchscreen display shows SWC Configured.
This process may take up to 3 minutes.
Note: If the touchscreen display does not load up, or the radio doesn't come on within 3
minutes, and/or the touchscreen display does not show SWC Configured, turn the vehicle off
and disconnect the 6536 harnesses from port "A" in the touchscreen display. Check all the
connections, reconnect the harness into the touchscreen display, and then try again.
4. Cycle the key off, then back on. If the driver's door is closed, open and close the door.
5. Refer to the Settings page within the Touchscreen Display Operation section. Ensure that all
factory features have been selected properly according to the options available for the vehicle.
6. Test all functions of the installation for proper operation, before reassembling the dash.
Note: The clock and compass in the driver's information center will no longer be functional.

FINAL ASSEMBLY

1. Secure the completed assembly to the dash using the factory hardware.
2. Reassemble the dash in reverse order of disassembly to complete the installation.
9
REV. 10/26/2020 INST99-6536

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido