gala gar Smart 400 TIG Pulse Manual Técnico De Instrucciones página 21

2. TRANSPORT AND INSTALLATION.
2.1. TRANSPORT AND PACKAGING.
Knocks and sudden movements must be avoided when transporting the equipment. In any case, the packaging
must be protected from water.
HANDLE THE EQUIPMENT CAREFULLY, IT WILL LAST LONGER !
2.2. ELECTRICAL SUPPLY INSTALLATION.
ELECTRICAL INSTALLATIONS SHOULD ONLY BE HANDLED BY SPECIALISED PERSONNEL.
The location must fulfill the following conditions:
Place: Dry and ventilated. Far enough away from the welding area in order to prevent the dust caused by the
-
welding process from getting into the equipment. Never work in the rain.
The distribution panel where the machine has to be connected must have the following elements, at least:
-
DIFFERENTIAL SWITCH (ID): Bi-polar or Tri-polar with a minimum sensitivity of 300 mA. The aim of this switch is
to protect the personnel from direct or indirect contact with electrical parts under voltage.
AUTOMATIC CIRCUIT BREAKER (IA): Bi-polar. A 32 A IA is recommended.
IMPORTANT! Verify that the wire is connected to a plug with an efficient earth tap. The plug must be adequate
for at least 25 A. If a longer supply hose or connection to an extension must be used, bear in mind the values of this
table.
Length
Up to 150m
> 15 m Up to 50 m
BEFORE STARTING THE EQUIPMENT, VERIFY THAT THE ELECTRODE TONG IS
Smart 400 TIG Pulse
Smart 400 TIG Pulse
CROSS-SECTION
4 mm
2
6 mm 2
SEPARATED FROM THE WELDING MASS.
These values are for reference and are influenced
by the state of the conductors, connections and
ambient temperature.
21