Turning The Power On; Changing Between Input Terminals - Sharp LL-T1820-Н Manual De Funcionamiento

Connecting the monitor and turning the monitor on and off

Turning the power on

1. Turn on the main power of the monitor.
- When switching the main power switch on and
off, always wait for an interval of at least 5
seconds. Rapid switching may result in
malfunction.
2. Press the monitor's POWER button.
The power LED will light up orange.
3. Turn on the computer.
Press power button
When a signal is input from the computer, the
power LED lights up green, and the screen is
displayed (After power is turned on, it may take a
little time until the screen is displayed.)
- If the input terminal to which the computer is
connected has not been selected, the screen
will not be displayed. If necessary, perform
input terminal switching. (right column)
Notes: (when using an analog signal)
- If using the monitor for the first time or after
having changed the system settings during use,
perform an automatic screen adjustment (p. 18).
- When connecting to a notebook, if the notebook
computer's screen is set so that it is displaying at
the same time, the MS-DOS screen may not be
able to display properly. In this case, change the
settings so that only the monitor is displaying.
All manuals and user guides at all-guides.com

Changing between input terminals

Use the INPUT button to switch between signal input
terminals.
Main power switch
Turn on the computer
power supply.
ON
15
Input terminal 1
INPUT
INPUT-1
< >
The input signal type (ANALOG/DIGITAL) is
displayed within angle brackets < >.
Input terminal 2
INPUT-2
< >