Tiiwee Home Alarm Starter Kit Manual Del Usuario página 5

Remote Controls
Disarm: deactivate the Alarm unit
Arm button: activate the Alarm unit
Switch Voice: Switch from Chime to Siren and vice versa
Bell button: triggers a loud emergency alarm
First preparation of the Alarm unit
 Open the battery compartment of the A1 Siren and remove the protective slip. You
will hear a beep and the indicator light on the Alarm unit will light up from top to
bottom. Your Alarm unit is now active.
 Insert one 12V, 23A battery in each Door sensor.
Please note the correct orientation of the batteries (+ /-).
Pressing the buttons
IMPORTANT: There are 2 ways to press the buttons on your Alarm unit:

Short press: press the button for 1 second or less.

Long press: keep the button pressed for 5 seconds.
Usually, the long press of 5 seconds is used to enter a programming or pairing mode. This
procedure prevents that important settings are changed accidentally.
Using the Alarm unit
The alarm unit can be operated both through the remote control as well as by pressing the
buttons on the side.
Switch On: Long press the On/Off Button [ ] to switch the unit on. The lights on the front
will light up one by one from top to bottom when the unit is switched on and a beep will
be heard.
Switch Off: Long press the On/Off Button [ ] to switch the unit off. The lights on the front
will dim one by one from bottom to top when switching off. A beep will be heard.
Arm/Disarm: Make sure the Alarm unit is switched On. Now, short press the SET button
[ ] once. A beep will be heard and the visual indicator will light up once when the
unit is armed, and 2 beeps will be heard and the visual indicator will light up twice if the
unit is disarmed.
5