Important - Tiiwee Home Alarm Starter Kit Manual Del Usuario

IMPORTANT:

Your Alarm unit is equipped with a memory function. This means that the
Alarm unit will always resume with its last settings when switched On. If it was armed
when it was switched off, it will be armed when it is switched On again. However, if it was
disarmed when it was switched Off, it will be disarmed when switched On again. In this
case, to arm the Alarm unit just short press the SET button [
Change the sound: Make sure the Alarm unit is switched On. Change the sound by short
pressing the On/Off Button [ ] . A short confirmation sound will be heard if the sound is
changed.
Pairing sensors to the Alarm Unit: Please refer to the respective chapter on pairing
sensors.
Using the remote control
The supplied remote control will work with multiple Alarm units if required.
There are four buttons on the remote control:
Button
Disarm button
Arm button
Switch Voice
Bell Button
Pairing with sensors and remote control
The Alarm unit is already paired with the remote control and the sensors. Use this
procedure to connect more door & window sensors or PIR motion sensors from the Tiiwee
Home Alarm System.
IMPORTANT: The A1 Alarm Unit has a separate mode for pairing of remote controls and
another mode for pairing of sensors. The mode for pairing of remote controls is active
when all 4 LEDs are lit. The mode for pairing of sensors is active when just one LED is lit.
Action
Switch Off
Switch On
Change siren type
Alarm will sound
6
] .
What happens if pressed
Alarm unit is deactivated
Alarm unit is activated
Siren changes from chime to
alarm sound or vice versa
Siren sounds loud. Press
Disarm button to stop.