Publicidad
Idiomas disponibles
Idiomas disponibles
•
If the PBX is not installed properly using the securing correct methods, the PBX
may fall causing serious damage.
•
When driving the screws into the wall, be careful to avoid touching any metal laths,
wire laths or plates in the wall.
•
When this unit is no longer in use, make sure to detach it from the wall.
•
When placing the PBX onto the wall, make sure that the arrows on the metal
brackets are pointing upward. If the arrows are not pointing upward, the PBX may
fall, resulting in injury.
Note
•
For details about dimensions and weight of the PBX, see "General Description"
section in the PBX Installation Manual.
•
The illustrations shown in the document are based on the KX-NCP500.
Necessary Items
(Included, except Screw B which is provided with the PBX):
Top Bracket × 1
Wall Mounting Procedures
1.
Measure the actual space as indicated below to mark the 4 screw positions on the wall.
(The reference for wall mounting is on the last page of this guide.) Install 4 anchor plugs
in the wall and drive in 4 screws (A) leaving a gap of 5 mm between the screw head and
the wall.
Screw (A)
2
Bottom Bracket × 1
Anchor Plug × 4
87 mm
463 mm
192 mm
Screw A × 4
(For use in
(For use in
concrete)
concrete)
Installation procedure for concrete walls.
Hammer
Anchor Plug
30 mm
Screw (A)
Screw (A)
Drive the
screw
5 mm
to this point.
Screw B × 6
8 mm
Publicidad
