Broan Elite E54000 Manual Del Usuario página 10

Ocultar thumbs Ver también para E54000:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PREPARE SUPPORT
FRAME, cont'd.
7. Hang the support frame from the support
frame bracket (located on ceiling).
Securely fasten with (4) 3.9x9.5mm
mounting screws. Fig. 9.
PREPARE THE HOOD
DUCTED AND NON-DUCTED HOODS
1. Assemble the Electrical Mounting Plate to
the hood with (2) 3.9x9.5mm mounting
screws and (2) serrated washers. Fig. 10.
DUCTED HOODS ONLY
2. Install the plastic discharge collar into the
opening of the blower discharge. Fig. 11.
3. Install 6" diameter metal duct over the
blower discharge. It must be long enough
to reach ducting that discharges to the
outside. Duct tape all joints to make them
secure and air tight.
NON-DUCTED HOODS ONLY
Note: the following material must be
purchased separately for non-ducted
recirculation installations:
Non- Ducted Recirculation Kit RK54
1. Discard the plastic discharge collar
supplied with the hood. Install the 5" to 6"
adapter (supplied with the non-ducted
recirculation kit) over the blower
discharge. Fig. 12.
2. Duct tape alljoints to make them secure
and air tight.
MOUNTING SCREWS
FRONT
MOUNTING
SCREWS
(3.9x9.5mm)
DUCTED
ONLY
NON-DUCTED
ONLY
- 10 -
(3.9x9.5mm)
SUPPORT
FRAME
BRACKET
SUPPORT
FRAME
FIG. 9
ELECTRICAL
MOUNTING PLATE
FIG.10
DISCHARGE
COLLAR
FIG.11
6"/5"
ADAPTER
FIG.12

Publicidad

Tabla de contenido
loading

Tabla de contenido