Settings Up Baud Rate, Protocol And Camera Address; The Menu - Provision ISR Auto Sync Focus Serie Manual Del Usario

Settings up baud rate, protocol and camera address

a) Press and hold for 3 seconds the
The following lines will blink on the screen:
PROTOCOL: PELCO D
b) While blinking – press on the
Protocol line will appear on the screen:
PROTOCOL: PELCO D
- To change protocol between PELCO-D / PELCO-C use the
Button on the remote.
7
button on the remote.
BAUD RATE: 2400
ADDRESS: 001
button on the remote,
c) Press the button again to set BAUD RATE – use
to change parameter.
- Press the again to set cameras ADDRESS – Use
to change parameter.
d) When done, press the

The Menu

This is the main menu page.
Press to enter the setup menu.
When you see the sign – press
EXPOSURE
SPECIAL
WHITE BAL
BACKLIGHT
RESET
EXIT
button to save and exit.
to enter the sub menu.
SETUP
ATW 1
OFF
8