Publicidad
Idiomas disponibles
Idiomas disponibles
E N G L I S H
4 PROBLEMS AND SOLUTIONS.
1.
Sand inside the pool.
2.
Sand even after the first bottom cleaning.
3.
Water leakage from the draining pipe.
4.
General water leakage.
5.
Too much pressure or very little water flow.
6.
Insufficient water flow.
7.
Cleaning cycles needed more and more closer.
8.
The pool water is never bright.
For any other eventual problem please contact your retailer!
5 MAINTENANCE.
Always remember to disconnect the plug from the socket before any maintenance operation and to do not place your hands in the
water if the pump is working. The filter maintenance is limited to its own cleaning through the backwash.
5.1. Water cleaning.
The visible impurities are eliminated through the filter, except the seaweeds, the bacterial and other microorganism that can contaminate the pool water.
To eliminate these polluting there are special products that must be regularly used and properly measured. Only in this way the pool water remain
hygienically cleaned and bright and therefore the bathers are comfortable. It is essential to filter twice a day for 4-5 hours, to regularly backwash (for 2÷3
minutes) and to wash the pool bottom at least once a week so that the pool water remain cleaned!
5.2. Bottom cleaning.
To wash the bottom the valve on the filter must be on FILTER position. The tool for the bottom cleaning must be connected to the skimmer with a
flexible tube. The pump must be switched off.
Important: completely refill with water the tube that is connected to the tool for the bottom cleaning so that the pump cannot aspire air. No air must enter
the filter. If there is air switch off the pump and empty the air from the suction tool.
Slowly move the tool and clean in this way all the bottom. The filter systems with no pre-filter work with a basket Skimmer!
6 SAFETY PROCEDURES.
Never place your hand in the water if the pump is working.
Always connect the pump cable with a 30 [mA] differential switch.
If the cable is damaged please ask to a specialized technician.
Before operating for any reason the pump always disconnect the plug from the socket.
The application is limited to a domestic use.
7 GUARANTEE.
7.1. General aspects.
i.
In accordance with these dispositions, the seller guarantees that the Product corresponding to this Guarantee does not present any conformity
defect at the moment of its delivery.
ii.
The period of validity of the Guarantee is of two (2) years, calculated at the moment of delivery of the Product itself.
iii.
Als een overeenstemmingstekort zou verschijnen en de koper het aan de verkoper tijdens de periode van Waarborg zou meedelen, moet de
verkoper het Product herstellen of vervangen.
iv.
Voor het geval dat het niet mogelijk zal zijn om het Product te herstellen of te vervangen, kon de koper op de resolutie van het verkoopcontract
aandringen.
v.
The parts replaced or repaired by virtue of this guarantee, will not postpone the expiry of the guarantee of the original Product, but will have their
own guarantee.
vi.
In order the present guarantee to be valid, the buyer will have to bear out the purchasing and delivery date of the Product.
vii.
If the buyer would adduce a conformity defect of the Product when more than six months have passed from its delivery, he should bear out also
the origin and the existence of the notified defect.
viii.
The present Certificate of Guarantee does not limit or prejudice the rights the consumers are entitled to by virtue of national regulations of
imperative type.
7.2. Particular condition.
i.
The present guarantee covers the products which this manual refers to.
ii.
The present Certificate of Guarantee is to be applied only in the European Union's countries.
iii.
In order this guarantee to be valid, the buyer will have to strictly follow the Manufacturer's indications included in the documents delivered with the
Product, as long as this is applicable, according to the range and model of the Product.
iv.
If a specific calendar for replacing, maintenance or cleaning of some parts or elements is specified, the guarantee will be considered valid only in
case this calendar has been respected.
7.3. Limitations.
v.
The present guarantee is to be applied only for sales to consumers, meaning with "consumer" the person who buys the Products for purposes not
related to his professional activity.
vi.
A guarantee covering the normal wear and tear due to the use of the Product is not granted. As regards parts, elements and/or perishable
materials such as batteries, bulbs etc., one will act following what established in the documents delivered with the Product.
vii.
The guarantee is not valid in case the Product: (I) has been object of an incorrect treatment; (II) has been repaired, maintained or manipulated by
a not authorized person or (III) has been repaired and equipped with not original parts. If the conformity defect of the Product would be due to an
incorrect installation or starting, the present guarantee answers for it only if such installation or starting is included in the sale contract of the
Product and has been realized by the seller or on his responsibility.
Nome file: 20.10.326 - ISTRUZIONI SF 25-200 _BIDONE SF_.doc
It is normal to have a little sand inside the pool after it run for a while. After a
first bottom cleaning this problem should be solved.
Sand type too thin. Make sure the quality of the sand you purchased it is
suitable for this kind of job.
Make sure the pipe O-Ring is well fixed.
Make sure you tighten correctly all the different points.
Check there are no obstruction on the Skimmer, pre-filter (if included) or tubes.
Start a back-wash.
The pump is not trigger correctly. Trigger the pump like illustrated in the
instructions of the pump.
Check the eventual presence of seaweeds in the pool and if needed add a
disinfectant or a PH level corrective.
Make sure you choose the right dimensioned filtration system for your kind of
pool.
Pagina/Page 7- di/of 28
Revisione 11 del 08/09/2009
Publicidad
