Tools; Using The Tools; How To Attach - Hoover SteamVac Manual Del Propietário

usinG the tools

A. Powered Hand Tool has rotating brushes for
extra scrubbing action on small carpet areas,
carpeted stairs and upholstery.
B. Stair/Upholstery Nozzle has a built-in brush to
help provide the scrubbing action some spots may
need for removal.
C. Nozzle Cleaning Tool for removing lint and/or
debris from nozzle before storage
how to attaCh hose
CAUTION
!
To reduce the risk of injury from moving parts,
unplug cleaner.
4.2 To prevent possible leaking, remove Clean
Water Solution Tank by pressing down on tank
handle (D) and pulling forward; set tank aside (do
not set tank on furniture).
Remove hose from storage rack.
Step on handle release pedal and lower carpet
cleaner handle until it rests on the floor.
Unlatch back part of Dirty Water Tank and remove lid.
4.3 Pull Dirty Water Tank front panel (E) up one inch
then rotate forward so it is horizontal to floor.
4.4 Replace panel with converter (F). Slide
converter halfway down opening until it is firmly in
place.
4.5 Before connecting tube (G) to cleaner, make
sure black tabs are extended by pulling collar
toward tube.
Open door on hood labeled "Stair/upholstery
Cleaning Connection". Press round solution tube
connector onto round projection inside door.
Press connector collar down firmly to ensure that
it is fully connected.
4.6 The tank replaces in a hinge-like manner.
Position front of lid under tabs (H) on front of tank.
Rotate lid down onto tank.
Make sure lid is secure on all sides before
cleaning.
For full suction, it is important that the Dirty Water
Tank lid is properly secured before cleaning.
Reverse procedure to remove hose and solution
tube.
Raise carpet cleaner handle to upright position.

4. tools

(Available on select models only)
(Available on select models only)
!
4.1
A
C
4.2
d
4.4
F
4.6
H
Actual model may vary from images shown.
13
b
3.20 4.3
e
e
4.5
G