DXV Orchard D35130 Instrucciones De Instalación página 7

ABOVE COUNTERTOP INSTALLATION
I
SINK INSTALLATION
Step 1. Position sink allowing sufficient distance to the finished wall based upon faucets chosen (Deck mount
or Wall mount). Mark the center of the drain on the countertop as a guide for the installation location.
Step 2. Mark a 7 inch (178 mm) diameter on the counter centered on the mark. Cut opening using
appropriate cutting tool for countertop material.
Step 3. Place a layer of sealant around the bottom edge of the sink where the sink and counter will make
contact. Then replace sink back into position. You can also carefully mark the perimeter of the sink on the
counter and apply the sealant on the counter instead of applying it on the bottom edge of the sink. Fill any
voids and remove excess.
7" (178mm) DIA.
IN COUNTERTOP
OUTLINE OF SINK
7" DIA. 178mm)
II
ASSEMBLE AND INSTALL P-TRAP AND DRAIN CONNECTIONS
Assemble and install P-trap drain connections in accordance with
manufacturer's instructions. Connect trap to drain assembly hand
tight to check alignment. It may be necessary to cut off part of the
tailpiece (area "B") or part of the horizontal leg of the trap (area
"C"). Secure joints for watertight assembly.
III
INSTALL FAUCET
Carefully locate and install faucet to countertop in accordance with manufacturer's instructions.
Ensure you provide adequate clearance for supply lines and faucet operation.
Connect supply lines to shutoff valves. Turn on water supply valves and water-test installation.
CUTOUT
Y"
CUTOUT
FINISHED WALL
X"
COUNTERTOP
7
SINK
SINK
OUTLINE
SEALANT
C
B
791598-100 Rev. D