Delta 36x36 Manual De Instalación página 6

Wall installation (continued)
5. Prepare for Plumbing Fixtures
◘
Measure and mark location for plumbing fixtures on back
of side panel.
! CAUTION: Drill chuck can damage panel. Drill holes from
back side of side panel.
◘
Using proper size hole saw, cut out plumbing fixture holes
from back side of panel.
7. Verify Side Panel Fit
◘
Position and verify that side panels are straight and square.
Y Y
X X
6. Apply Fire Retardant Pad
Y Y
X X
◘
Remove backing from self-adhesive pad.
◘
Center pad over mixing valve hole and press firmly onto
back side of panel.
◘
Using a utility knife, trim pad to reveal mixing valve hole
8. Drill Holes in Side Panel Flange
Drill 3/16" holes at all stud locations on top flanges and along
side flanges every 12" to 18" apart.
! CAUTION:
Do not drill 3/16" holes directly into studs. Drill chuck can
damage panel. Use an extended bit holder to reduce risk of
drill chuck hitting panels.
6
B a c
s i d
Drill 3/16" clearance holes into flanges only.
f
k o
l
a n e
e p
P/N 27794 09/13