Delta 36x36 Manual De Instalación página 8

Wall installation (continued)
13. Secure Side Panel
◘
Install side panel, sliding the side panel into gap between
wall and back panel, pressing firmly into corner and against
studs. Push in and down until panel tops are even and
curved area on side panel fits against back panel.
IMPORTANT! Gaps between flanges and studs must be
less than 1/8". Insert shims to fill gaps.
◘
Secure top and side flanges to studs with 1-1/4" screws.
! CAUTION:
Use panhead or roundhead screws. Do not
overtighten screws, this can cause panel to crack.
◘
Repeat steps 12 and 13 to secure other side panel.
15. Apply Sealant
S APPLY SEALANT to all seams.
14. Brace Side Panels
Shim Shim
1-1/4" 1-1/4"
(3,17cm) (3,17cm)
◘
Install temporary braces to hold side panels tight against
studs while adhesive dries.
◘
Protect surface of wall set where it will contact braces.
! CAUTION:
prevent wall panel deflection.
IMPORTANT!
adhesive dry time before removing brace.
IMPORTANT!
sealant dry time before use.
◘
Install plumbing fixtures and fittings per manufacturer's
instructions. Check for leaks at all connections before use.
! CAUTION:
screw into flanges or product damage will occur.
8
Braces should be placed on wall studs to
Follow manufacturer's instructions for
Follow manufacturer's instructions for
If installing finished wall material, do not
P/N 27794 09/13