Ega Master 58770 Manual De Instrucciones página 18

Connection with power adaptor:
- Before wiring, make sure the power supply is off.
- To wire to power, please use shielded cable.
Radio Frequency and ID planning:
Radio Frequency Channel (in
The wireless Wrench and Receiver should use the same RF channel frequency to
communicate; otherwise, wireless Wrench and Receiver cannot communicate to each other.
Setting:
- Each wrench should be assigned with a
Receiver it belong.
- Each Receiver should be assigned with a
than one Receiver, otherwise the behavior is unpredicted.
- The setting of wrench must be assigned with the
Wireless Wrench Network Topology
18
FREQUENCY AND ID SETTING
setting):
, and this
, and this
PC (WithTightening System) and Receiver
should be unique within the
should be unique if there is more
of the Receiver that it belongs.