Environmental Regulations - Ega Master 79666 Manual De Instrucciones

Dispose of machine and worn out/defective machine tools according the local/national
regulations. Fully disassemble the machine for the necessary disposal. Separate materials
according to local environmental specifications. Dispose of environmentally hazardous greasing,
cooling or cleaning agents in order to avoid environmental contamination.
When working on or with the equipment, it is imperative to observe all legal
requirements in regards to waste-disposal and proper recycling. In particular
during installation, repair and maintenance work, water damaging agents, such
as
• lubricating grease and oil,
• coolant,
• solvent containing cleaning agents
When working on or with the equipment, it is imperative to observe all legal requirements
in regards to waste•disposal and proper recycling. In particular during installation, repair and
maintenance work, water damaging agents, such as:
• lubricating grease and oil,
• hydraulic fluid,
• coolant,
• solvent containing cleaning agents must not leak into the ground or reach the
sewage system.
These materials must be stored, transported, contained and disposed of in suitable
containers!
The following table shows possible problems and their causes:
Problem, cause, remedy
Problem
Sabre saw does not start
Low stroke rate
Stroke rate too high
50
DISPOSAL

ENVIRONMENTAL REGULATIONS

TROUBLESHOOTING
Cause
Not connected to compressed
air supply
Operating pressure too low
Hose diameter too small
Flow rate too low
Operating pressure too high
Flow rate too high
Remedy
Connecting and opening of the
compressed air supply
Increase operating pressure
Choose larger hose diameter
Increase flow rate
Consider max. operating
pressure acc. to technical
specification
Reduce flow rate