Accessory Storage Bag Assembly; Installing Accessory Storage Bag; Removing Accessory Storage Bag; Accessory Storage - RIDGID WD1450 Manual Del Operador

SP6542-2.qxd 6/26/07
Accessory Storage Bag

Installing Accessory Storage Bag

1. Position rods of accessory storage bag
directly over accessory rod receptacles
in dust drum.
2. Slide rods of accessory storage bag
into accessory rod receptacles until
fully seated.

Accessory Storage

Your accessories may be stored in the
accessory storage bag, or in the two
locations on the rear caster feet.
NOTE: Insert female end of extension
wand into the holder sleeve as shown.
Female End
of Extension
Wand
1:20 PM Page 8
Accessory
Storage Bag
Rods
Accessory
Rod
Receptacles
Accessory
Storage Bag
Hose Storage
Areas
8
Removing Accessory Storage
Bag
1. Pull straight up on rods of accessory
storage bag until bag is loose.
NOTE: Powerhead will need to be
removed before accessory storage bag
can be removed.
Pull
Straight
Up
Accessory
Storage Rod

Cord Wrap

When vacuuming is complete, unplug the
cord and wrap it around the power
assembly as shown. The cord should wrap
under the pull handle (above the inlet) and
around and under the cord wrap of the
motor cover.
Push/Pull Handle
Powerhead
Cord Wrap
Power
Cord