Task Force 020390 Manual Del Usuario página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Attach Handle and Accessory Tray
1. Place handle (B) onto handle supports
connected to main unit (A). See Figure 1.
Make sure holes in handle align with holes on
handle supports.
NOTE: It may be necessary to move the handle
supports from side to side so the handle will
slide over the handle supports to better align
the holes.
2. Insert carriage bolts (AA) through holes
from back of unit and attach a plastic knob
(BB) from front of unit. See Figure 2. Tighten
by hand.
3. Place accessory tray (F) over holes on
handle (B, viewing from front of unit). See
Figure 3. Push the tree clips (CC) into the
holes until they sit flush with the accessory
tray surface.
4. Insert supplied accessories in spaces
provided in accessory tray. See How to Use
Accessory Tray.
Add Engine Oil
1. Place pressure washer on a flat,
level surface.
2. Clean area around oil fill and remove yellow
oil fill cap/dipstick.
3. Using oil funnel (optional), slowly pour
contents of provided oil bottle (G) into oil
fill opening. See Figure 4.
NOTICE: Improper treatment of pressure
washer can damage it and shorten its life.
DO NOT attempt to crank or start the engine
before it has been properly serviced with
the recommended oil. This may result in an
engine failure.
4. Replace oil fill cap/dipstick and fully tighten.
Add Fuel
Fuel must meet these requirements:
Clean, fresh, unleaded gasoline.
A minimum of 87 octane/87 AKI (91 RON).
High altitude use, see High Altitude.
Gasoline with up to 10% ethanol (gasohol) or
up to 15% MTBE (methyl tertiary butyl ether)
is acceptable.
Figure 1
Figure 2
AA
Figure 3
F
Figure 4
8
B
A
BB
B
CC
G

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

02039101013660101373

Tabla de contenido