Kenmore 790.90102 Manual De Uso Y Cuidado página 25

To Remove and Replace Oven Door
1. Open the door to the fully opened position.
2. Pull up the lock located on both hinge supports and engage it in the hinge levers. You may
have to apply a little downward pressure on the door to pull the locks fully over the hooks.
3. Grab the door by the sides, pull the bottom of the door up and toward you to disengage
the hinge supports. Keep pulling the bottom of the door toward you while turning the top
of the door toward the range to completely disengage the hinge levers.
4. To replace the door, reverse the door removal steps. Make sure the hinge supports are fully
engaged before unlocking the hinge levers.
The door is heavy. After removing door, lay it flat on the floor with its inside
facing down.
Hinge lever
Hook
Lock in
Hinge
normal position
Support
To Remove and Replace Storage Drawer
To Remove the Drawer:
1. Pull the empty drawer out to the roller guide stop.
2. Tilt the drawer up and pull it out over the rollers.
To Replace the Drawer:
1. Insert the rear end of the drawer into the opening.
2. Fit the drawer end rollers onto the guide rails.
3. Push the drawer in until it stops, then lift to allow the rollers to clear the
roller guide stop, and push in.
Lock engaged
for door removal
25
General
Cleaning
FEATURE OVERVIEW
• To Remove and Replace
Oven Door
• To Remove and Replace
Storage Drawer
Hinge Slot
Door removed
from range
Rails
Roller
Front Frame
Storage