Cleaning; Storage; Troubleshooting; Replacement Filter - Husky HV02000 Manual Del Usuario

SP6689-2 Husky HV0200_ES.qxd

Cleaning

To keep your Wet/Dry Vac looking its
best, clean the outside with a cloth
dampened with warm water and mild
soap.
To clean the drum:
1. Dump debris out.
2. Wash drum thoroughly with warm water
and mild soap.
3. Wipe out with dry cloth.
Problem
Vac will not pick up dirt
Vac will not run
WARNING: If any of the power head assembly parts should become
detached or broken, exposing motor or any other electrical components,
operation should be discontinued immediately to avoid personal injury or
further damage to the vacuum. This vacuum has no user serviceable parts.
Replacement filters are available where
you purchased your vac. The stock
number is VF2000.
4/18/08 3:48 PM

Storage

Before storing your vac, the dust drum
should be emptied and cleaned. The cord
should be wrapped around the unit and
the hose should be stored as described
in the cord/hose storage section in this
manual. Accessories should be kept in
the same area as the vac so they can be
readily available. The vac should be
stored indoors.

Troubleshooting

Cause
1. Clogged filter
2. Clogged hose
3. Air leak
1. No electricity

Replacement Filter

11
Page 11
Remedy
1. Clean or replace filter
(follow instructions on
page 10)
2. Remove hose and
clear debris.
3. Make sure power
head is securely
attached to dust drum.
1. Make sure electrical
outlet has voltage.
(A qualified electrician
may need to be
contacted).