Emptying The Dust Drum; Blowing Feature - Husky HV02000 Manual Del Usuario

SP6689-2 Husky HV0200_ES.qxd
Emptying the Drum
WARNING: To reduce the risk of
!
injury from accidental starting,
unplug power cord before emptying
the drum.

Blowing Feature

Your vac contains a blowing feature. It
has the capability to blow sawdust and
other debris. It is excellent to use to blow
dust and debris out of garages or off
patios and driveways. Follow the steps
below to use your vac as a blower.
1. Locate blowing port of your vac.
2. Insert one end of the 4 foot x 1-1/4 inch
hose into the blowing port.
4. Turn vac "ON"and you are ready to use
your vac as a blower.
WARNING: Always wear safety
!
eyewear complying with ANSI Z87.1
(or in Canada CSA Z94.3) when
using as a blower.
4/18/08 3:48 PM Page 9
1. Place vac squarely on a stable surface,
such as ground, floor, bench, etc.
2. Remove the power head assembly of
the wet/dry vac by pulling outward on
the latches located on each side of the
vac. Lift off the power head assembly.
3. Dump the drum contents into the
proper waste disposal container.
Unlatch
Power Head
Assembly
WARNING: To avoid injury to
!
bystanders, keep them clear of
blowing debris.
CAUTION: Wear a dust mask if
!
blowing creates dust which might
be inhaled.
! CAUTION: To reduce the risk of
hearing damage, wear ear
protectors when using the
vac/blower for extended hours or
when using it in a noisy area.
9