Safety Information - Style selections LT2026WWMV Manual Del Usuario

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install
the product.
WARNING
Before cutting, drilling or hammering into any wall surface, verify the location of electrical, plumbing
and gas lines. Cutting any of these may cause serious injury. If needed, contact your electrician,
plumber or service person.
PREPARATION
Before beginning assembly of the product, make sure all parts are present. Compare parts with
package contents list. If any part is missing or damaged, do not attempt to assemble the product.
Plumbing should be done by a qualified plumber and in accordance with national and local plumbing
codes. For shipping purposes, corner protectors are attached to the cabinet body and need to be
removed. If necessary, use small pliers to remove staples.
Estimated Assembly Time: 40 minutes
Tools Required for Assembly (not included): Drill, Hacksaw, Pipe Wrench, Pencil, Silicone
Caulk/Sealant, Plumbers Putty, and Wood Shims
ASSEMBLY INSTRUCTIONS
1.
Disassemble strainer kit (B), by unscrewing locknut
and removing rubber washer. Unscrew nut and remove
tailpiece washer from strainer kit (B).
NOTE: Tailpiece washer will be used in step 9.
Apply a sufficient amount of plumbers putty between
the strainer and sink basin (A). Insert strainer body
through the drain hole in the sink basin (A).
Hold strainer body firmly in place, position rubber washer
on strainer body under the sink basin (A).
Screw lock nut onto the threaded shank of the strainer
body and tighten with a pipe wrench.
NOTE: DO NOT OVERTIGHTEN and remove any
excess plumbers putty from strainer body and sink
basin (A).
1
A
B
5
B
IS2626