7.
Place a bead of silicone caulk/sealant around the top
edge of the cabinet body (E). Carefully set sink basin (A)
into cabinet body (E).
Place a bead of silicone caulk/sealant (not included)
on the backside of the backsplash on sink basin (A).
Place hose guard with soap dish (D) into either side of
the sink basin (A).
NOTE: Hose guard with soap dish (D) is shown on the
left side of sink basin (A) and can be used to secure the
discharge hose from washing machine.
8.
Slip nut (O) onto wall tube (R).
Position two nuts (O) and one washer (P) onto
tailpiece (N).
Slip tailpiece (N) into p-trap (Q). Slip washer (P) down
tailpiece (N) and fasten using nut (O).
Insert wall tube (R) into p-trap (Q) and hand tighten
all nuts (O).
Holding plumbing assembly in the desired position,
measure wall tube (R) and tailpiece (N), to required
length. Remove wall tube (R) and tailpiece (N) and cut
with a hacksaw.
NOTE: Cut untapered end of tailpiece (N) and
wall tube (R). Be sure to remove burrs with a file or
sandpaper.
7
A
8
R
8
D
N
O
E
O
P
Q
IS2626