Antenna Installation; Installing And Removing The Battery Pack; Attaching And Removing The Belt Clip - Maxon SP - 150 Serie Instrucciones De Operation

Antenna Installation

Attach the antenna by turning clockwise into the antenna
receptacle on top of the radio.

Installing and Removing the Battery Pack

Hold the radio face down in your hand. To attach the battery
pack, pick up the pack by the sides and hold it so that the four
charging contacts are facing upward, positioned toward the
bottom. Visually locate the "up" arrows embossed inside the
radio, then place the pack onto the radio, positioning the top
of the pack to slightly cover the arrows. Using your fingertips,
ensure the pack is flush with the radio sides. The channels in
the pack will align with guides on the radio.
Slide the battery pack upward slowly. A click will verify that
the battery pack is securely positioned.
Remove the battery pack by holding the radio face down
in your hand. Slide and hold the battery latch (at the base of
radio) then gently apply pressure to move the battery pack
slightly downward. The pack will release from the radio's
guide rails. Lift the battery pack straight up and away from
the radio.

Attaching and Removing the Belt Clip

The belt clip attaches to the radio's battery pack. To attach
the belt clip, hold the clip and slide it into the recessed area
at the top of the pack. A click will verify the clip is securely
positioned. To remove the clip, press and hold the release
tab toward the clip while gently pulling the belt clip assembly
off the radio.
5