Iso Ddin Radio Provision - Metra 99-7809B Instrucciones De Instalación

ISO DDIN radio provision

1. Attach the (8) PC-7871B panel clips to the
99-7809 radio trim panel.
2. Attach (1) #8 speed clip provided to each
radio bracket as shown. (Figure A)
Note: This will be the lower mounting
point where the factory 5/16" screws
were removed.
3. Attach the radio brackets to the radio
trim panel using (4) #8 x 3/8" Phillips
screws provided. (Figure B)
4. Slide the radio into the assembly and
secure with screws supplied with the
radio. (Figure C)
5. Clip the a/c vents removed in step #7
of the disassembly into the radio trim
panel.
6
KIT ASSEMBLY
(Figure A)
(Figure B)
6. Locate the factory wiring harness and
antenna plug in the dash and make all
necessary connections to the radio. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
7. Plug in and clip the Metra climate control
assembly into the dash. (Figure D)
8. Proceed to the Kit Programming section
of this manual before mounting the
radio assembly into the dash and
completing the dash assembly.
9. After the Metra climate controls are
programmed and tested, mount the
new radio assembly into the dash,
secure the lower radio bracket mounting
points with (2) #10 x 3/4" Phillips screws
provided, and reassemble the dash in
reverse order of disassembly.
Continue to Wiring Instructions
(Figure C)
(Figure D)
|
1.800.221.0932 MetraOnline.com