Custom Harness Installation - Mopar 82209702 Instrucciones Para La Instalación

Custom Harness Installation

Ignition switch connector
A. Locate ignition switch connector,
directly behind the ignition switch.
Release the secondary lock. While
pushing on main release, remove
connector from ignition switch.
B. Connect the harness 5-way female
connector to the vehicle's ignition
switch.
C. Connect the harness 5-way male
connector to the vehicle's 5-way
ignition connector previously
removed from the ignition switch.
Ground
D. Using a supplied 1/4" screw,
secure the black ground wire with
ring terminal to the metal at the left
kick panel.
Center-Splice Procedure
Parking Light Connection
E. Locate the White/Violet (L217) wire
in harness, found low in the left
kick panel area. Center-splice the
harness White/Violet wire into this
wire, following the center-splice
procedure. This wire will show
+12V when the parking lights are
turned on.
7