GE ASH18 Manual Del Propietario E Instrucciones De Instalación página 4

About the controls on the air conditioner—models with touch pads.
Features and appearance will vary.
ENERGY
SAVER On
Timer
On
Air Conditioner Controls
(on some models)
ON/OFF
Turns air conditioner on and off.
Display
MODE
Use to set the air conditioner to COOL or FAN
mode.
Increase
Use to set temperature when in COOL mode.
FAN
Use to set the fan speed at LOW, MED or HIGH.
CIRCULAIRE
Turn on to provide continuous side-to-side
air circulation.
For fixed side-to-side air direction, turn ON
until the desired air direction is obtained,
then turn it OFF.
ENERGY SAVER–
ON—The fan and compressor cycle on and
off. This results in wider variations of room
temperature and humidity. Normally used
when the room is unoccupied. Note: The fan
will continue to run for a short time after the
compressor cycles off.
OFF—The fan runs all the time, while the
compressor cycles on and off.
This switch must be set at OFF in order to use
the fan settings (on the mode control).
Remote Control
s
To ensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
s
The remote control signal has a range of
4
up to 21 feet.
v w
/Decrease Pads
Controls the fan.
Low Med High
Fan Fan Fan
On On On
Cool Mode On
Fan
Only
On
Air Conditioner Controls
(on some models)
TIMER
ON—When the air conditioner is off, it can be
set to automatically turn on in 1 to 12 hours
or 1 to 24 hours (depending on model) at its
previous setting. Each touch will set the time
in hours.
OFF—When the air conditioner is on, it can
be set to automatically turn off in 1 to 12
hours or 1 to 24 hours (depending on
model). Each touch will set the time in hours.
To cancel the timer, press the TIMER pad
until the display time disappears.
SLEEP
Press to set the air conditioner to run for
8 hours before it automatically shuts off.
When the SLEEP pad is pressed, SLEEP displays
for approximately 15 seconds, then shows the
time remaining.
One hour after the sleep timer is set, the set
temperature will automatically increase 2°F.
To cancel the sleep mode, press the SLEEP pad
a second time.
Note: The sleep timer will be cancelled if the
TIMER, ENERGY SAVER or MODE pad is pressed.
Remote Control Signal Receiver
s
Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
s
Make sure batteries are fresh and installed
correctly—see the Care and Cleaning section.
ENERGY
CIRCULAIRE
On SAVER On
Timer
On