GB USA
Instruction Manual
Age: from 2 years upwards
This car runs on 3 alkaline 1.5 Volt "AA" batteries. Batteries are included.
The batteries that are supplied with this toy, at the point of sale, are intended for store demonstration purposes
only. Before using the toy for the first time, it is recommended to replace the batteries in the compartment.
WARNINGS
For your child's safety: WARNING!
Before using the product, remove and dispose of any plastic bags and any other packaging elements and keep them
out of reach of children. Suffocation risks
• Always use under constant supervision of an adult.
• Check the toy regularly for signs of wear and damage and to ensure that it is assembled correctly. Should
any part be visibly damaged, do not use the toy and keep it out of children's reach.
• Never touch the car wheels when it is running.
• Do not use the toy on the main road.
• Do not use the toy on wet, sandy or dusty surfaces.
TECHNICAL FEATURES
Diag. A ON/OFF (II / O) switch; battery compartment cover.
Diag. B Charging system
INTRODUCTION TO THE TOY
This toy is an electrically charged vehicle which is switched on by "pressing" the car itself.
The more times the vehicle is pressed into the ground, the further the vehicle will travel.
The maximum distance that the vehicle can cover is about 10 metres (this distance can decrease considerably
according to the environmental conditions).
HOW TO USE THE TOY
• Switch the vehicle on by pushing the ON /OFF (II / O) switch (Diag. A-1) under the car to II.
• The vehicle is charged by pressing the car downwards (Diag. B)
• When it has recharged, the vehicle will start off in a straight line. The more times the vehicle is pressed into
the ground, the further the vehicle will travel.
• Always switch the vehicle OFF when it is not being used, moving the switch to (Diag.A-1) to O.
WARNING: the "DEMO (I)" position on the switch is used for internal store demonstration purposes only.
Make sure this option is not selected when using the product as this mode uses a limited amount of functions.
FITTING AND/OR REPLACING BATTERIES
• Batteries must only be replaced by an adult.
• To replace the batteries: Loosen the screw on the battery compartment cover (Diag. A-2) with a screwdriver
and open the cover. Then remove the spent batteries and fit new ones, ensuring that they have been fitted
with correct polarity (as shown on the product), close the battery cover, and tighten the screw.
• Only use alkaline batteries of the same type or equivalent to the type recommended for the correct function
of this product.
• Never mix alkaline, standard (zinc-carbon) or rechargeable (nickel-cadmium) batteries.
• Never mix new and old batteries.
• Always keep batteries and tools out of the reach of children.
• Do not short-circuit the battery terminals.
• Always remove spent batteries from the toy to avoid the danger of leakage from the battery which can
damage the product.
TurboTouch
8
• Al
• Re
• Do
tia
• If
be
• Do
• Th
• Th
of it
of e
recy
you
eith
buy
The
in th
The
can
trea
and
pos
avai
CL
• Cle
• Pro
ART
war
the
Mad