PowrMax
WARNING: RISK OF INJECTION
INJURY THROUGH LEAKING HIGH-
PRESSURE HOSE
Wear and tear and links as well as usage that is
not appropriate to the purpose of the device can
cause leakages to form in the mortar hose. Liquid
can be injected into the skin through a leakage.
PREVENTION:
•
Mortar hoses must be checked thoroughly before they are
used.
•
Replace any damaged mortar hose immediately.
•
Never repair defective mortar hoses yourself!
•
Avoid sharp bends and folds: the smallest bending radius
is about 80 cm.
•
Do not drive over the mortar hose. Protect against sharp
objects and edges.
•
Never pull on the mortar hose to move the device.
•
Do not twist the mortar hose.
•
Lay the mortar hose in such a way as to ensure that it
cannot be tripped over.
Only use TITAN original-mortar hoses in order to
i
ensure functionality, safety and durability.
The risk of damage rises with the age of the
i
mortar hose.
TITAN recommends replacing mortar hoses after
6 years.
WARNING: RISK OF INJURY DUE TO
MOVING PARTS
PREVENTION:
•
Never operate the mortar spraying machine if the rotor is
exposed or if the container has been removed.
•
Do not reach into the rotor when it is moving. Risk of
crushing. Caution if you have long hair. Only wear close-
fitting clothes at work. Do not insert objects or body parts
through the protective grid.
•
Risk of crushing when folding in the handles, assembling
the pump unit and connecting the mortar hose.
HAZARD: GENERAL
This product can cause severe injury or property
damage.
PREVENTION:
•
Never decouple mortar hose or disassemble machine when
under pressure. Note pressure reading on pressure gauge.
•
When performing maintenance work, always switch off
mortar spraying machine, disconnect mains plug and
ensure it cannot be plugged back in by mistake.
•
Do not spray down the motor and control unit of the
mortar spraying machine with a water-jet, high-pressure
cleaner or high-pressure steam cleaner. Danger of short-
circuits caused by water ingressing.
SAFETY PRECAUTIONS
5